I have a new(refurbished) feeder unit, but it still can't print, the paper just starts through the feeder when it stops and says jam at A, left side door open
This usually means that the door sensor is dirty or faulty.
Or is not being read by the engine board.
Manually depress the switch to see if the error goes away.
If you can get into diagnoatics, do a component test. And a sensor test.
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.