I have two 6200 units. The first one works fine but when I power up the second unit, I do not get any display or light indicators. It shuts down after about 30 seconds. Any suggestions, or do I just hang on to it for a parts machine for my working unit? Thanks, everyone!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 6200 woes! N display or llights on start-up
- Thread starter PCMasters
- Start date
Michael52x
Technical User
Try re-seating the logic module, and all cables/plugs.
The display may be bad. Swap with the other unit to check.
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
The display may be bad. Swap with the other unit to check.
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
- Status
Similar threads
- Locked
- Question
- Locked
- Question
