mschreiber
Technical User
I've replaced the toner and the printer still shows 0% black. I've seen in the service manual that the sensor printer does a test and with a full toner no light is seen by the sensor. Then the printer does a reset to 100%. But this is not done even when i replaced it with a very new original toner.
Next problem is the fuser - the system shows "replace" and stopped printing. Is there a fuse like in the fuser roll or how does the printer detect a new fuser?
Next problem is the fuser - the system shows "replace" and stopped printing. Is there a fuse like in the fuser roll or how does the printer detect a new fuser?
