Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Phaser 350
- Thread starter meaddav
- Start date
The error reads as follows:
"Y-axis position failure, the drum is not where is should be, possibly because the drum position sensor electronics have failed, or because the motor drive or drive belts have failed, or because something is physically blocking the motion of the drum"
What I would check is the sensor on the left side of the printer. As the drum moves, the sensor reads where the position of the drum is with the red LED in this black tripod assembly. If you do not see a red LED, then your problem lies here. I would replace the position sensor and/or the I/O Circuit Board that the position sensor plugs into just below.
I hope this helps.
"Y-axis position failure, the drum is not where is should be, possibly because the drum position sensor electronics have failed, or because the motor drive or drive belts have failed, or because something is physically blocking the motion of the drum"
What I would check is the sensor on the left side of the printer. As the drum moves, the sensor reads where the position of the drum is with the red LED in this black tripod assembly. If you do not see a red LED, then your problem lies here. I would replace the position sensor and/or the I/O Circuit Board that the position sensor plugs into just below.
I hope this helps.
- Status
Similar threads
- Locked
- Question
- Locked
- Question