Well I have this Phaser 350 error code 05,002.42 Y Axis I am told.
I just replaced the circuit board on the lower left side, I replaced the disc and pick up unit on the end of the drum. The drum drive belt is good the motor has been tested, the drum is free to turn. This printer has 4200 copies made where do I go from here I get the same error?
I just replaced the circuit board on the lower left side, I replaced the disc and pick up unit on the end of the drum. The drum drive belt is good the motor has been tested, the drum is free to turn. This printer has 4200 copies made where do I go from here I get the same error?