I have worked with Pervasive 2000i on a Novell 4.20 server for years, and now I'm trying to change to Pervasive V8.
I have installed Netware Support Pack 9 in the server and I did the post installation steps to set up UNICODE as described in the TID psql3111 in Pervasive Knowledge Base.
The UNICODE.NLM shows when you type the MODULES command at the server.
The first funny thing I get when I start PERVASIVE v8 setup is a message saying that Support Pack 9 is not detected.
When you ignore this message, the installation runs without any further problem.
But when restarting the Novell server, I get the message : PSCORE initialization failed. UNICODE support files cannot be loaded.
Then, the only solution is to reverse the V8 installation and go back to 2000i.
Do you have any idea on what is happening?. Any suggestion will be appreciated.
Thanks !!,
Carmen
I have installed Netware Support Pack 9 in the server and I did the post installation steps to set up UNICODE as described in the TID psql3111 in Pervasive Knowledge Base.
The UNICODE.NLM shows when you type the MODULES command at the server.
The first funny thing I get when I start PERVASIVE v8 setup is a message saying that Support Pack 9 is not detected.
When you ignore this message, the installation runs without any further problem.
But when restarting the Novell server, I get the message : PSCORE initialization failed. UNICODE support files cannot be loaded.
Then, the only solution is to reverse the V8 installation and go back to 2000i.
Do you have any idea on what is happening?. Any suggestion will be appreciated.
Thanks !!,
Carmen