I'm doing some reconfiguration of a switch stack consisting of a 5520 and two 5510 switches. I would like to remove one of the switches permanently (ie, it won't be replaced). Do I need to reset the stack back to factory defaults to get them to forget about this switch?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Permanent removal of switch from 5500 stack
- Thread starter curtismo
- Start date
DaddyOfThree
Technical User
If you want to erase all mention of the previous switch then the ask would be yes, you'll need to factory reset the stack.
You could though just renumber the stack and it would continue to function with whatever configuration you had on it.
Cheers!
You could though just renumber the stack and it would continue to function with whatever configuration you had on it.
Cheers!
- Status
Similar threads
- Locked
- Question
- Locked
- Question