Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Performance Monitoring
- Thread starter hxman
- Start date
goombawaho
MIS
Netware Remote Manager is a good place to start just to get an idea of any problems that might be happening. Sort of like a general check up when you go to the doctor, you can view the current status of the server.
To Login to the Remote manager
TCP/IP address:8008
What it can show you
To Login to the Remote manager
TCP/IP address:8008
What it can show you
marvhuffaker
MIS
There ARE NO bottlenecks in NetWare 6. 
The bottlenecks are in your hardware, disk system, memory (or lack of)..
A properly running server should run at about 2-3% utilization (at least less than 5%) on average. Running higher? that will cause noticeable performance issues. So you troubleshoot to find out what is causing high utilization, once you get that, your server will run sweet.
You can look at the MONITOR.NLM tool or better the remote manager mentioned above.
Marvin Huffaker, MCNE
Marvin Huffaker Consulting, Inc.
A Novell Platinum Partner
The bottlenecks are in your hardware, disk system, memory (or lack of)..A properly running server should run at about 2-3% utilization (at least less than 5%) on average. Running higher? that will cause noticeable performance issues. So you troubleshoot to find out what is causing high utilization, once you get that, your server will run sweet.
You can look at the MONITOR.NLM tool or better the remote manager mentioned above.
Marvin Huffaker, MCNE
Marvin Huffaker Consulting, Inc.
A Novell Platinum Partner
- Status