Guest_imported
New member
- Jan 1, 1970
- 0
- 0
- 0
Does anyone know if there are any "standards" for a VAX 4500A running OVMS in terms of sustained fault rates, DIO, etc.? Or where I can find them?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Performance metric "standards" for VAX 4500?
- Thread starter Guest_imported
- Start date
- Status
Hi,<br>
<br>
You can find these answers via the Guide to VMS Performance manual, via DEC PS software reports, and often the monitor utility is helpful in spotting problems. Generally the UAF process quotas for a user and the Sysgen PQL_M----- and PQL_D----- quotas can be set to reduce page faulting to some extent. You should also see that your pagefiles are sufficient and keeping them off the system disk is usually a good idea. <br>
<br>
If you need further assistance, send me mail at susan@neu.edu<br>
<br>
You can find these answers via the Guide to VMS Performance manual, via DEC PS software reports, and often the monitor utility is helpful in spotting problems. Generally the UAF process quotas for a user and the Sysgen PQL_M----- and PQL_D----- quotas can be set to reduce page faulting to some extent. You should also see that your pagefiles are sufficient and keeping them off the system disk is usually a good idea. <br>
<br>
If you need further assistance, send me mail at susan@neu.edu<br>
- Status
