PERC 2/SC Raid Controller

[bigdog619sd]

I have a Dell Power Edge 2300 running winnt server
with a PERC 2/SC Raid Controller.
I am trying to get a Backup GHOST image of a drive on this controller.

and I can't find any PERC drivers for DOS,win95,98 to add
to my Ghost bootdisks.

Does anyone have any suggestions on how to see the
Hard Drive from a DOS,95,98 Boot Disk ???

Thanks for your help...

..... David

 

[yowza]

David,

If you are talking about Symantecs or Nortons' Ghost software, they require NIC drivers. Following is a link that may help you.

http://service4.symantec.com/SUPPORT/ghost.nsf/docid/2000040710064725

Good luck,
Yowza

 

[bigdog619sd]

Thanks Yowza, But I already have NIC Drivers.
Where I am having difficulty is accessing the SCSI
Drives that are connected to the PERC 2/SC
(Power Edge Raid Controller)
I can't find PERC drivers for DOS,95,98
The manufacturer has these following drives only...
Available PERC Drivers = WIN2000,WINNT,LINUX and NETWARE.

Any Suggestions... ???

 

[Guest_imported]

Did you find your drivers? I am trying the same thing and ran into the same road block.

 

[bigdog619sd]

I have found a solution.
If you email me I will send you the drivers.
dhaynes@qm.com

 

[bigdog619sd]

I now use this site for my Network Bootdisks.

http://www.nu2.nu/bootdisk/network/

cheers...
bigdog

 

[ewiley]

For the archives (if anyone else has this problem and needs the drivers) Dell has a diagnostic disk with the ASPI drivers for all the PERC's on it at

http://support.dell.com/FileLib/Format.aspx?ReleaseID=R61011

Hope this helps anyone in the future.