Has anyone ever ran the following command in the pdt> load, on release 5.5? If so do this impact the system in anyway? Trying to gather some information for a vendor and just want to make sure this is not service affecting in anyway.
******* See Commands below: *******
To verify the phone’s duplication:
1. On the PABX, press <Ctrl> + p +d + t.
2. In the PDT shell of a CS, type the following:
pdt> symload # except for CPP CS
pdt> su
3. Run the crShowCRParam command:
4. -> crShowCRParam (all the requested TNs appear)
-> crShowCRParam [TN in Hex] (Prints only the number of the TN in Hex)
The TN represents the extension number and will be supplied by the Nortel Site Engineer.
In this example, the phone is programmed with the VoIP Logger’s IP address and port.
******* See Commands below: *******
To verify the phone’s duplication:
1. On the PABX, press <Ctrl> + p +d + t.
2. In the PDT shell of a CS, type the following:
pdt> symload # except for CPP CS
pdt> su
3. Run the crShowCRParam command:
4. -> crShowCRParam (all the requested TNs appear)
-> crShowCRParam [TN in Hex] (Prints only the number of the TN in Hex)
The TN represents the extension number and will be supplied by the Nortel Site Engineer.
In this example, the phone is programmed with the VoIP Logger’s IP address and port.
