I have just installed the PDM on our firewall. Now when I open it, I get this pdm location issue. First it finds our site-to-site vpn address and our second class c addresses and ask which interface it resides on. After selecting the outside it starts creating the topology of the network. It then creates all these pdm location commands into the running configuration followed by an error [ERR] pdm location 216.0.0.37 255.0.0.255 inside. If I cancel, I can not use the PDM except for monitoring, if I continue it gives me this error over and over. What is the PDM locaiton and why do I need 25 of them in my config? Do I need it? How can I get past this? Where is it getting this IP address and subnet mask?