I get the following error when attempting to add a specific target:
"Could not add target because the target "C:\pbimmp\master.pbt" could not be created".
If I remove "master.pbl" from master.pbt and substitute the name of a successfully added target library then I can add the target even if all other libraries in the target are the same as the original. I am having this problem with 2 targets out of about 50. The others load up fine.
Is there anybody out there that has experienced this problem and knows a solution?
Could it be because the target library was created with a later version of PowerBuilder?
"Could not add target because the target "C:\pbimmp\master.pbt" could not be created".
If I remove "master.pbl" from master.pbt and substitute the name of a successfully added target library then I can add the target even if all other libraries in the target are the same as the original. I am having this problem with 2 targets out of about 50. The others load up fine.
Is there anybody out there that has experienced this problem and knows a solution?
Could it be because the target library was created with a later version of PowerBuilder?