goin2cisco
MIS
How do I do it? I tried the method for a 303 but it did not work...
Thanks!
Tom
Thanks!
Tom
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Password recovery on Baystack 350???
- Thread starter goin2cisco
- Start date
- Status
Hi I am not sure of the recovery procedure for a 303, but I did read a previous post about this and they recomended trying the following.
Power off , wait about 30 seconds, Power on...
Within 15 seconds type : NetICs<cr>
You will then be in enable mode... You should be able to retrieve the password from the security menu.
This is a procedure for 450 T's but it's worth a try
best of luck
Bob ^^
Power off , wait about 30 seconds, Power on...
Within 15 seconds type : NetICs<cr>
You will then be in enable mode... You should be able to retrieve the password from the security menu.
This is a procedure for 450 T's but it's worth a try
best of luck
Bob ^^
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question