Partner Voice Mail

[seryozha]

Is there a version of Partner Voice Mail that can either disable the option 0 or set it to go to a mailbox instead of x10? Also need to be able to disable tie timeout xfer to x10 or have it go to the same mailbox.

 

[TouchToneTommy]

Any release of Partner Messaging allows you to set the Dial-0/Timeout option to go to the Operator, General Mailbox, Disconnect, Transfer to an Extension, or Transfer to a Mailbox. The Dial-0 and Timeout are the same.

Partner Mail VS R5 allows you to change the Dial-0/Timeout to go to a specific extension, other than 10

 

[seryozha]

is partner messaging different from partner voice messaging? I am not sure what release i am using or how to tell. I do know it is a ACS R4. I can find anywhere in the manual i have on how to set the timeout/dial 0 option. When i log in and press 4 for the selector codes it doesn't give me any such option. Is it somewhere else?

 

[TouchToneTommy]

Partner Voice Messaging is the 2-port PCMCIA card that is installed in the ACS Processor itself. No, you cannot change the Dial-0/Timeout option, it is fixed to Ext. 10.

 

[seryozha]

ok, kewl. thanks.