Partner R6, Intercom/Page gives busy signal

[integrators2]

I installed an R6 ACS Processor and when I access the paging system (Intercom *70) it goes busy. When I do this on the system in my office it works fine (allows me to intercom/page). I thought I had a bad card so I had my vendor send another one, but it does the same thing. I can't find any info for any special programming for the page port. What am I missing?

 

[UpstatePaul]

You should just press Intercom 70 - This will work.

Intercom * 70 pages the speaker and all phones, if no phones are assigned into callinig group 1 Intercom *70 doesn,t work

 

[UpstatePaul]

To put the phones in calling group 1 and make Intercom * 70 work From ext 10 or 11 press feature 0 0, left intercom key 2 times, # 502, 1, (Extension #) - then 1 to assign