partner plus vs partner 11

[skip555]

am I correct that the only differences between a partner plus rel 4.1 and a partner 11 rel 4.1 is the cabinet expansion capablity ?

 

[samh30]

Thats one of the differences,there are also ,partner 2 support Caller ID and Hyprid mode (pools) and partner plus not.,also partner 2 has ASA and DXD built in and partner plus not.I hope that helps. Good Luck!

http://www.samhassan.com

 

[itpphoneguy]

Hi skip555,
You need 206EC cards for caller ID. Change the battery before getting into programming the unit unless you know that's been done. That goes for both types.

-Chris

 

[samh30]

ITpphoneguy,
Partner plus does't support caller ID ,even if use 206EC or 400EC.The partner 2 release 3 or higher will support caller ID. Good Luck!

http://www.samhassan.com

 

[skip555]

thanks for the respsonses

 

[itpphoneguy]

Hi samh30,
The last phrase was referring to the battery change. But thanks for pointing out that out.
-Chris

 

[skip555]

what battery are you talking about ?

 

[itpphoneguy]

Hi skip555,
There is a small 3.6 V nicad battery for memory backup. It's a three pin type like they used to use on computers. Varta still make them new. In Canada they cost $8-$10. A nicad is normally good from 4 to 7 yrs. I always change them when setting up a used Partner system for a customer.
These are soldered in, but not difficult to change. They exist in the processor.

-Chris