Partner Messaging not answering 777

[Ecycler]

I recently re-installed a partner ACS 3.0 system with a 6.0 upgrade card and a "PARTNER Messaging" module (ID # V700323207). All seems fine except that when I press intercom and dial 777 I get a busy signal. The green light is illuminated on the Messaging module.

 

[budbyrd]

Have you programmed the ports??? They need to be in hunt group 7. #505. If you don't know for sure which ports they are on that module call each port. If they are VM ports they will answer.

Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'

 

[tylamb19]

If you have programmed the extensions like budbyrd said, and even calling them individually does not work, check the messaging module's LED and listen to the module closely. Mine did this same sort of behavior when the internal hard drive died, and if you listened closely you would hear the hard drive do a single "click" noise and the green LED would go dark for a tiny split second. Then repeat every few seconds.