Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Partner Mail V S Rel 3.0

Status
Not open for further replies.

FireTec

IS-IT--Management
Jul 7, 2004
20
US
Who would the red LED flash after power cycle. This card was working before power cycle, now it is not...
 
Try turning off system and reseating the module, if problem persists it is most likely a hard drive error.
 
When you turn it back on, listen for the drive to spin up. If it doesn't, turn the system off. Remove the vm card and give it a whack with your hand. Not really hard. Reinstall the vm and power up the system. If the vm is now working, have people get the important messages off the unit.
You can either send it out for repair or replace it. Expensive piece, but it's a good time to upgrade if you can afford to.
-Chris
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top