Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Partner II module swap 1

Status
Not open for further replies.
mufka

mufka

ISP
Dec 18, 2000
587
US
I have a Partner II system that has a 206.E Module R3.1 that has two bad ports. If I swap in another module, will I have to do anything, or will it just work?
 
Sort by date Sort by votes
Well, you may have to reprogram the system from scratch, if the nicad batteries in the Partner II processor are not recharging.

Roll the dice, change it out!!!! What's the worst that could happen!
 
Upvote 0 Downvote
It was powered off for several hours so I would assume that the batteries are ok. When I powered it back on, two ports were bad on one of the modules.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

F
  • Locked
  • Question
Avaya Partner
Replies
4
Views
378
TouchToneTommy
TouchToneTommy
jsaad
  • Locked
  • Question
Partner Messaging SMTP
Replies
2
Views
331
jsaad
jsaad
MerlinRob
  • Question
Partner ACS R7 - Extension coverage / simultaneous ring 3
Replies
5
Views
803
MerlinRob
MerlinRob
endel2005
  • Locked
  • Question
Avaya Partner ACS auto attendant
Replies
10
Views
708
telemarksman
telemarksman
CPM86
  • Locked
  • Question
Partner ACS DSL 1600 card an caller id. Is it no like the T1 module?
Replies
1
Views
209
Westi
Westi

Part and Inventory Search

Sponsor

Back
Top