i'm puzzled,1605-r won't hold secondary internal address
won't hold clock ,won't be telnetted ?..from WWW
i however can consol and telnet from the lan.
and will hold 2nd subnet and clock till i reload.after a wr
and copy run start of course.any ideas ?
i noticed message from bootstrap, and ios
was upgraded but old bootstrap still beeing used
could it be the problem ?
//////////////////////////////////////////////////////////
System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
C1600 platform with 16384 Kbytes of main memory
program load complete, entry point: 0x4020060, size: 0x165eac
%SYS-4-CONFIG_NEWER: Configuration from version 12.1 may not be correctly understood
%Command or function not supported in this software
%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
program load complete, entry point: 0x2005000, size: 0x2badd7
Self decompressing the image : ########################################################### [OK]
Cisco Internetwork Operating System Software
IOS (tm) 1600 Software (C1600-Y-M), Version 12.1(2)T, RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Tue 16-May-00 09:34 by ccai
Image text-base: 0x02005000, data-base: 0x025B95E8
cisco 1605 (68360) processor (revision C) with 12288K/4096K bytes of memory.
Processor board ID 26581291, with hardware revision 00000004
Bridging software.
X.25 software, Version 3.0.0.
2 Ethernet/IEEE 802.3 interface(s)
System/IO memory with parity disabled
8192K bytes of DRAM onboard 8192K bytes of DRAM on SIMM
System running from RAM
7K bytes of non-volatile configuration memory.
4096K bytes of processor board PCMCIA flash (Read/Write)
Secondary addresses not allowed with negotiated addresses
/////////////////////////////////////////////////
whatever#sh ru
Building configuration...
Current configuration:
!
version 12.1
service timestamps debug uptime
service timestamps log uptime
service password-encryption
!
hostname whatever
!
enable secret 5 iaintthatdum
enable password 7 yournozy
!
username xxxxxxxxx password 7 yourtoocurious
!
clock timezone utc -5
ip subnet-zero
ip host-routing
no ip finger
ip name-server xxx.xxx.xxx.xxx
ip name-server
ip name-server
!
ip dhcp pool DHCP
network 192.xxx.x.0 255.255.255.240
dns-server xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx
default-router 192.xxx.x.8
lease 0 0 1
!
interface Ethernet0
ip address 192.xxx.x.8 255.255.255.240
ip address 192.xxx.z.1 255.255.255.248 secondary *notstay*
ip nat inside
no cdp enable
!
interface Ethernet1
mac-address xxxx.xxxx.xxxx
ip address dhcp ----hook up to cable modem service--
no ip redirects
no ip unreachables
no ip proxy-arp
ip nat outside
no cdp enable
!
ip nat inside source list 1 interface Ethernet1 overload
ip classless
ip route 0.0.0.0 0.0.0.0 Ethernet1
no ip http server
!
logging trap debugging
no cdp run
banner motd ^C
!
line con 0
transport input none
line vty 0 4
password 7 aintgonatellyu
login local
transport input telnet
!end
won't hold clock ,won't be telnetted ?..from WWW
i however can consol and telnet from the lan.
and will hold 2nd subnet and clock till i reload.after a wr
and copy run start of course.any ideas ?
i noticed message from bootstrap, and ios
was upgraded but old bootstrap still beeing used
could it be the problem ?
//////////////////////////////////////////////////////////
System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
C1600 platform with 16384 Kbytes of main memory
program load complete, entry point: 0x4020060, size: 0x165eac
%SYS-4-CONFIG_NEWER: Configuration from version 12.1 may not be correctly understood
%Command or function not supported in this software
%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
program load complete, entry point: 0x2005000, size: 0x2badd7
Self decompressing the image : ########################################################### [OK]
Cisco Internetwork Operating System Software
IOS (tm) 1600 Software (C1600-Y-M), Version 12.1(2)T, RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Tue 16-May-00 09:34 by ccai
Image text-base: 0x02005000, data-base: 0x025B95E8
cisco 1605 (68360) processor (revision C) with 12288K/4096K bytes of memory.
Processor board ID 26581291, with hardware revision 00000004
Bridging software.
X.25 software, Version 3.0.0.
2 Ethernet/IEEE 802.3 interface(s)
System/IO memory with parity disabled
8192K bytes of DRAM onboard 8192K bytes of DRAM on SIMM
System running from RAM
7K bytes of non-volatile configuration memory.
4096K bytes of processor board PCMCIA flash (Read/Write)
Secondary addresses not allowed with negotiated addresses
/////////////////////////////////////////////////
whatever#sh ru
Building configuration...
Current configuration:
!
version 12.1
service timestamps debug uptime
service timestamps log uptime
service password-encryption
!
hostname whatever
!
enable secret 5 iaintthatdum
enable password 7 yournozy
!
username xxxxxxxxx password 7 yourtoocurious
!
clock timezone utc -5
ip subnet-zero
ip host-routing
no ip finger
ip name-server xxx.xxx.xxx.xxx
ip name-server
ip name-server
!
ip dhcp pool DHCP
network 192.xxx.x.0 255.255.255.240
dns-server xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx
default-router 192.xxx.x.8
lease 0 0 1
!
interface Ethernet0
ip address 192.xxx.x.8 255.255.255.240
ip address 192.xxx.z.1 255.255.255.248 secondary *notstay*
ip nat inside
no cdp enable
!
interface Ethernet1
mac-address xxxx.xxxx.xxxx
ip address dhcp ----hook up to cable modem service--
no ip redirects
no ip unreachables
no ip proxy-arp
ip nat outside
no cdp enable
!
ip nat inside source list 1 interface Ethernet1 overload
ip classless
ip route 0.0.0.0 0.0.0.0 Ethernet1
no ip http server
!
logging trap debugging
no cdp run
banner motd ^C
!
line con 0
transport input none
line vty 0 4
password 7 aintgonatellyu
login local
transport input telnet
!end