I am trying to connect an AS5300 to a Lucent Definity PBX.
Settings on the AS5300 are:
Connection is E1 ISDN PRI
Should be DSS1 signalling
framing: CRC 4
line coding HDB3
We are having problems.
On the gateway it shows that physical layer is up and probably there is a framing problem.
According to my collegue by phone:- On the PBX
framing is set to CRC Yes
line coding is set to HDB3
signalling is set to ISDN PRI
country protocol: ETSI
On the trunk:
group type: ISDN
public network: Yes
bit rate: 1200 (is this right??)
Please help if you have any ideas of setting that effect framing that are on the Lucent Definity
Settings on the AS5300 are:
Connection is E1 ISDN PRI
Should be DSS1 signalling
framing: CRC 4
line coding HDB3
We are having problems.
On the gateway it shows that physical layer is up and probably there is a framing problem.
According to my collegue by phone:- On the PBX
framing is set to CRC Yes
line coding is set to HDB3
signalling is set to ISDN PRI
country protocol: ETSI
On the trunk:
group type: ISDN
public network: Yes
bit rate: 1200 (is this right??)
Please help if you have any ideas of setting that effect framing that are on the Lucent Definity