organickarma
Programmer
This might seem like a silly question but it has been bothering me for a while and any amount of googling or reference has not provided me with a satisfactory solution.
I am using CR XI with Oracle 10.
I have a 4 parameter stored procedure which I use in my report. Report is built and all is well.
When I run this report I am required to manually type in the parameter values. Is there a way I can populate a list for each one of these parameters on stand alone CR
Also would this mean including another data source in my report to achieve this?
If not what is the best way to do this?
Any ideas on this would be appreciated!
I am using CR XI with Oracle 10.
I have a 4 parameter stored procedure which I use in my report. Report is built and all is well.
When I run this report I am required to manually type in the parameter values. Is there a way I can populate a list for each one of these parameters on stand alone CR
Also would this mean including another data source in my report to achieve this?
If not what is the best way to do this?
Any ideas on this would be appreciated!