I have a report from CR 8.0 that I imported into CE. I reset the datasource location, etc. On the parameters tab the parameters are all set to [EMPTY]. The parameters are BEGIN DATE and END DATE. I need to chnge them to "prompt user for new values when viewing". WHen I do this, and click OK it tells me I have to enter a date in the format DATE(#,#,####) and will not allow me to leave the "prompt for new values" option selected. Thanks in advance for any advice on this.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Parameters cant be changed
- Thread starter cisscott
- Start date
synapsevampire
Programmer
It wants a date, enter one.
Make sure you select Update afterwards.
-k
Make sure you select Update afterwards.
-k
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question