Panasonic KX-TD1232 PABX Password Not Working

[ShakeelAshraf]

I am a beginner to install a Panasonic KX-TD123 2 PABX which was already installed and dead in my office. I was tasked to UP the system.
Its power supply was not working, so I troubleshooted and finally managed to power up the device.
Next I performed a hard job for tracing the cables as these were damaged by the rats. I again managed to survive.
Next I started learning and programmed all the extensions and CO lines. As a result I managed to finally UP the complete system. The system was working with its default password 1234

Today while further programming the system for outgoing calls restriction, I got structed as I dont know where I made any mistake as I was unable to make any outgoing call. So I decided to reset the system.

The NORMAL/CLEAR switch was set to NORMAL and I pressed the RESET button. Then I set the NORMAL/CLEAR switch to CLEAR and pressed the RESET button.

But its pity on me, now I am unable to access the system using the default password 1234. I even tried ******* (7 times 8) but the system is not going to perform any kind of programming due to password.

You are requested to advice me for resetting the password.

 

[kizo]

1. Slide the System Clear Switch to the "CLEAR" position.
2. Press the Reset Button
3. Return the System Clear Switch to the "NORMAL" position while the power indicator is
flashing (within approximately 10 seconds).


If the Time on digital phone is 1. Januar 1995, PBX is cleared

There are no stupid questions, there are only stupid answers!

 

[ShakeelAshraf]

Thanks kizo.
I already have tried this but failed.

Later on, I restarted the system after doing this and succeeded.

Thanks for your kind response.