Paging 2

[beybros]

We need help!!!!

We have a MICS with T-1 software. We are install a Bogen TSP60B paging amplifier and using existing Excutone speakers. We are having trouble paging....

Lex Davis

 

[ThePhoneGURU]

Has it been terminated onto the correct paging port of the KSU?

 

[beybros]

Tophonegurg,

I check the install manual(yellow/blue) for paging port.

 

[ThePhoneGURU]

I haven't used this in a while...and don't have the docs..but I thought it was BLK/SLT for Paging Output...
Sorry I can't be more help..
Maybe someone else can jump on this one..

 

[telemarv]

yl/bl of the the 2nd station amphenol. be sure you're on the right cable. be sure sets are allowed to page in programming. "existing speakers" are you sure speakers are compatible with amp... they may be self amplified and in need of power supply.

Marv
TeleMarv Services

http://www.telemarv.ca

 

[ThePhoneGURU]

I agree w/TeleMarv. If you can page internal to sets then something physical is going on..

 

[luv2ski]

i thought bogen was looking for a trunk port connection

ski season has started

 

[galfaro]

Did the speakers work before? Several things could be happenning, short or open pair on the speaker output.
Installation may not be right.
Go on the Page pair of the switch with a buttset and have someone make a page, if you hear it, your problem is not with the phone equipt.
Good Luck
Gabriel

 

[MontrealSoft]

use a wire-finder(buzzer)... when connected at the end of the pair that would otherwise go to the norstar ksu, you should hear the tester's buzz blasting through the speakers....

If the speakers are self-powered, place the tester on their input (your face away from the speaker output) and you should hear it again...

Luc

MontrealSoft.com

http://www.montrealsoft.com

 

[jerryreeve]

faq799-1799 for the wiring.
Black/slate for the PA audio out
Yellow/Blue for the PA relay control



----------------------------
JerryReeve
Communications Systems Int'l
com-sys.com

Mind like a Steel trap - Once used forever clamped shut.