Paging Volume resets every few hours 1

[GordonKapesMZ4]

Similar to the previous post....I have a softphone/Laptop connected to a remote location that pages to that small building. The laptop is connected to a paging amplifier that can't be turned up too loud because it is also sharing music. Also if they want to page in house....feedback is an issue if you turn the volume up.

Every few hours, after turning up the volume full blast on the softphone for paging, the phone resets due to network traffic and then defaults to the low volume.

Is there anyway to lock the paging volume on the i2050 phone?

Thank you,

 

[norstarboy125]

Sounds like you have some set up there, the first thing that comes to mind is make sure the system is set up to use set volume instead of system volume.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[GordonKapesMZ4]

Hi Jeremy,

Thank you for your response.

If the i2050 phone is set to "Set Volume" does that mean it will default back to the Set volume parameters and not the system parameters if it resets?

Thank you!

JP

 

[pccal]

I would advise you to trouble shoot the paging system itself.You did not mention what kind of paging system it is but the fact that you are adjusting volume controls to try and control feedback is not a good thing. I would look at some kind of feed back eliminator. Also most paging systems have seperate volume controls for music over paging & the actual volume of the page.

 

[norstarboy125]

Yes, when the system is set to use receiver/set volume versus system volume then the ext. will stay at the volume level until the end user changes it.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer