ericssonpro
IS-IT--Management
Am trying to link a paging system V-1109RTVA nine zone page control to an MD110 through an analogue trunk and the manual states that the V-1109RTVA may be accessed by connecting the W/BL and BL/w to the tip and Ring respectively of a Loop Start Trunk Circuit.
what i need to know:
1.what is a Loop trunk Circuit?
2.when i hooked the 2 lines that i have to an analogue phone device i can hear a tone, the voltage on the line is 24V, tried every posible combination of the route parameters none worked D5=1(SERV) & D8=0(VARC), i tried on on TLU11 & TLU44 didnt work at all, with TLU25 i can get a conecatin but cant send the voice to teh zones, can any one help me?
what i need to know:
1.what is a Loop trunk Circuit?
2.when i hooked the 2 lines that i have to an analogue phone device i can hear a tone, the voltage on the line is 24V, tried every posible combination of the route parameters none worked D5=1(SERV) & D8=0(VARC), i tried on on TLU11 & TLU44 didnt work at all, with TLU25 i can get a conecatin but cant send the voice to teh zones, can any one help me?
