Paging Route Help

[TomMonger]

Hello again,

We have a paging system at one of my buildings where the employees dial a 2-digit number to activate the page. I'd like to make this DID accessible. The page in this particular building is set up on a universal trunk card(the one in my building is set up on an analog DN).

How would I go about setting this up? I tried setting up a dummy 500 to forward to the paging 2-digit DN, but it didn't work. It kept going to the main system greeting. Someone had mentioned the inability to do "trunk to trunk" transfers. Is there a way around this?

Thanks,
-Tom in Scranton, PA

 

[Utreg]

Add any DID number you like to use to your RPAX or RPAN code (whatever applicable) in LD 57
This might work for you
regs,
@win

 

[TomMonger]

Thanks UTREG... but I'm not familiar with LD57. Would you mind going through the steps?

-Tom

 

[Utreg]

LD 57
REQ CHG
TYPE FFC
CUST 00
FFCT YES
ASRC
....
....
RPAX "This prompt"
RPAN "or this one"

first PRT, FFC, CODE ALL to see if you are using: RPAX or RPAN (meet me or non meet me paging) then CHG, FFC, CODE RPAX "did nr" to add

 

[TomMonger]

Thanks, Utreg...

I pulled that list and I don't see either RPAX or RPAN. Does this mean I'm "SOL"???

Thanks,
-Tom