Paging over PA in remote office in SCN 1

[MTVilla]

Is it possible to set up paging via Small community networking over P.A. system in a remote office?

 

[IPGuru]

it the PA is connected to an analog extn configured as a paging port then you should be able to ring the user for the amp as usual.
if you are using a trunk then you will need to configure shortcodes at site A that will call the paging short code at site B

example to page at site B dial 666 (or whatever is currently set up)

at site a create sthe following short code

SC 666
number 666 (or . in this case if you want)
line group id <ougt ogoing id for Voip line>
Featurer Dial.

666 will be sent down the link from site A & processed at Site B.

 

[MTVilla]

I think I'm going to give that a try. THanks a lot IPGuru.

 

[MTVilla]

It works! Thanks again!