Paging Issue

[mamut0o1]

Hello; I have a Magix PBX. I recently changed two phones to a different cubicle. One I renamed it and the other one I just changed the cable from the pannel. Now I can't hear pages in the one I just change the cable and the other I could hear the page VERY low. Does this sounds like a programming issue or you think I might have a bad wire?


thanks for any repies.
Mm

 

[CarGoSki]

Are you talking about paging over the speaker on the speaker phones via all page using 799?

Use system monitor unless of course you are a Tard then it IS the fault of the pbx.

 

[Telecomboy]

Did you verify the speaker volume is turned up on both telephone sets. They might have been reset during the move.

 

[SYQUEST]

On the Legend/Magix, when you unplug the set some settings return the default setting, ie. display contrast, and some volume settings. Don't know if this is version specific or not.

....JIM....