Paging Issue

[morgansdad]

I recently put in an Option11C at a remote site connected by tie lines and cannot get the paging to work. I have a page code of xx2 (TSC) from one site to the other which works fine however the page code of xx3 (TSC) will not work the other way on the new switch. DCH msg. points to FEAT:NAS and PROGRESS:ORIG ADDR IS NOT ISDN? Any ideas? It is programmed like the original I pulled out? Maybe a package?

 

[johnpoole]

not isdn end to end is not part of the problem.. (make a call from any station and read the msgo).. in the direction that it does not work use a dgt to insert the acod of the page route on the inbound call..

i dial 1234,,tsc.. ld 87 puts in on the tie route, if i insert the acod of the page route,,, i should hit the page route.

john poole
bellsouth business
columbia,sc

 

[cpm23]

At the NACC prompt in your paging route, try putting in PGNC or PGNU. Add NAC to RCAP of your D-channel. There may be other ways to make it work but I had to set it up like that for a small, three switch network. My paging access codes are set as DSC, not TSC. Look in the Networking Features and Services NTP (Call Page Network Wide).

 

[morgansdad]

Thank you very much, NACC was PGNR, changed to PGNU and it worked. Thanks again.

 

[johnpoole]

good, take care of morgan. have a good weekend

john poole
bellsouth business
columbia,sc