I am going to be setting up a new paging horn with a new power supply to a customers warehouse. This site already has many horns already in place and I wasn't the one who put them in. Can anyone offer any insight as to how I should go about trying to install this? It's going to be part of a MICS system. If you have any ideas or need additonal info, I'll be happy to offer.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Paging Horns
- Thread starter rval1980
- Start date
curlycord
Programmer
If they have many horns they may have an Amplifier on site, if so just follow the other cables into the inputs on the AMP.
Sometimes you can even just run a wire from one speaker to the other and bridge the connection.
Not much we can do to help unless we know model of speakers and amp on site and what you plan on bringing.
Sometimes you can even just run a wire from one speaker to the other and bridge the connection.
Not much we can do to help unless we know model of speakers and amp on site and what you plan on bringing.
Deweyhumbolt
Technical User
First question is are they self-amplified or use an amplifier. It will tell you what kind of speaker and what type of wire.
Adversity is Opportunity
Adversity is Opportunity
RikRodgers
Vendor
If they do run off an amp, you can still half tap the amp's input to the voice pair of your self amplified speaker.
Deweyhumbolt
Technical User
If they're self-amplified you can half-tap. Just answer that question.
Adversity is Opportunity
Adversity is Opportunity
- Status
Similar threads
- Locked
- Question
- Locked
- Question