I am trying to configure an external Bogen UTI1 paging amp to an Avaya G450. I have an outgoing, loop start trunk set up with a TAC and an MM711 analog port 003v108 set up within the TG. I am using a 4 digit access code, the access code 7937 is configured in the uniform dialing plan as an AAR. In the aar ana table I pointed 7937 at route 137 and then to TG 137, I receive reorder tone and no circuit/channel available. I have also attempted the Loudspeaker Paging configuration.Obviously, I am doing this wrong. Any help is appreciated, Thanks in advance.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Paging (G450 Gateway using External UTI1 Bogen Paging Amp)
- Thread starter tacoma1
- Start date
dialtonebone
Technical User
You shouldn't need the TAC to be in UDP or any of that stuff. Just create the trunk group and dial the TAC.
- Thread starter
- #4
1st Thanks for the response, I appreciate that. Actually shortly after I posted this I figured it out. After making an entry in loudspeaker paging I got it to work. That is what I was missing. I am now able to use the 4 digit Voice TAC followed by #.
- Status