Paging Code

[ccally]

Hi I have a norstar meridian phone system in our office, and I want to be able to use a "shortcut" code to page, right now its feature 63.. Is it possible to do something so that we can just pick up the phone and dial a number like 8#1 and page instead of having to use feature.

 

[PERRYPJ]

No but you can program one of your buttons on the phone

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[atdjr123]

If you want to page all just f*3/press the button you want to set as your page all button/press f610
If you want a choice between phone and speakers/ follow same procedure/press f60

http://www.voiceconnectplus.com

Voice Connect Plus, Inc.
have a great day and a better tomorrow

 

[Sam173]

I think if your paging system requires a line port to page then you would set the line on your set and press it to then enter your codes to page

 

[atdjr123]

I didn't know that you could use a line port for paging on a norstar....with all do respect, why not just program a page button. just curious...

http://www.voiceconnectplus.com

Voice Connect Plus, Inc.
have a great day and a better tomorrow

 

[norstarboy125]

In certain cases you have to use a trunk port for paging, if you didn't know that could be done on a Norstar system then I'd say you haven't been installing them very long. As previously stated you can program the page code onto a button. Do you have any zones set up or just single zone paging? That would determine the proper page feature to program on your sets.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[atdjr123]

what would an example of a certain case????

http://www.voiceconnectplus.com

Voice Connect Plus, Inc.
have a great day and a better tomorrow

 

[atdjr123]

you should pay attention to who the started the thread before commenting on someone's lack of knowledge or experience based on a question asked.
this an info forum is it not??????

http://www.voiceconnectplus.com

Voice Connect Plus, Inc.
have a great day and a better tomorrow

 

[Sam173]

do read the other thread on paging that is running
Valcom products goes through a line port, a Tortech does not, I believe, in the end I think there are 2 types of paging, self amplified and 70V system, both have different approach.

thread799-1679387

 

[norstarboy125]

Sorry you took my comment the wrong way, when dealing with various paging equipment is when I've came across having to use a trunk port versus the page port. I guess I just found it odd that you have never seen that before if your a Norstar installer.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[GordonKapesMZ4]

I've seen the separate paging controller in places like schools, which have an independent paging system and they are smart enough to want to tie their Norstar or Meridian 1 system into the PA system, via an analog trunk port vs. using the proprietary microphone or handset supplied with the PA system.

 

[allworxguy]

The only reason to use trunk side paging is if there is a requirement for external zone paging and/or talkback paging.

Marv

http://www.telemarv.ca

 

[atdjr123]

No Problem Norstarboy, I may have taken it the wrong way. I have seen that implemented on comdial and panasonic systems awhile back but never on norstar since we have always used valcom paging horns or an a paging amp w/ 70 v and common contacts. But the info is good to know. Thanks

http://www.voiceconnectplus.com

Voice Connect Plus, Inc.
have a great day and a better tomorrow