Just installed an IPO 11.0.4.2 SE one of the expansion IP500v2 gateways has a PA system hanging off a standard analogue phone 8 card. You call the number and leave the message with the PA System then hang up, previously this was on a Siemens ISDX and this worked fine, with the IPO it plays the message back but has about a 6 second solid tone (Dial tone or disconnect tone at a guess) on the end of the message which is annoying. You can get it to work by dialing # when you finish your announcement which is accepted by the PA system as end of message, but the users are a bit set in there ways (same ISDX for 20 years or so). Any idea why its not clearing down the call instantly on hanging up or anything I can change?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
PA System Cleardown
- Thread starter bignose21
- Start date
kwing112000
Vendor
how do you have the port set? you can try IVR port or paging speaker and see if it helps.
Kevin Wing
ACSS Small and Medium Enterprise (SME) Communications
ACS- Implement IP Office
ACA- Implement IP Office
Vive Communications
Kevin Wing
ACSS Small and Medium Enterprise (SME) Communications
ACS- Implement IP Office
ACA- Implement IP Office
Vive Communications
- Thread starter
- #3
- Status