Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

P5 server attached to an HMC and on-board serial adapters

Status
Not open for further replies.

w5000

Technical User
Nov 24, 2010
223
PL
the 510 box seems to have two serial ports.
as I have read then box is managed by HMC, the serial ports are controlled by service procesor. in my case single HMC is used.

Qeustion:
is there a way to configure a virtual serial adapter on LPAR so it can be used for remote console openning on older P4 server?
I would like to cable a serial adapter/port from P5 with serial port on P4 server and then use kermit to open a console from P5 LPAR.

is it feasible? if yes what steps are to be done?
 
The on board serial ports are NOT available for general use when the POWER5 server is managed by an HMC.

The virtual serial adapter devices are only available as virtual serial console device to the HMC.

HTH,

p5wizard
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top