P-T-P PRI IPO to CM CLID Not Working

[sheldoom]

Hi, I have an IP Office R11 connected to a CM via P-T-P PRI.

The IPO has Voice Networking Licenses, I have setup the IPO as QSIGB, CM is QSIGA, ICRs, Trunk Group IDs and Short Codes are programmed. Calls are working when dialing both directions, but not receiving caller ID on either end.

Any ideas what I'm missing?

Thank you!

"It's all ball bearings these days" Fletch F. Fletch

 

[janni78]

Check in Monitor with ISDN L3 trace enabled if the IPO is sending CLI.

When I connected to CM I configured it as a regular PRI instead of QSIG since the CM can act as master for PRI, that way you don't need Voice Networking licenses.

"Trying is the first step to failure..." - Homer

 

[sheldoom]

Janni, When you set up as regular PRI you got CLID both ways?

"It's all ball bearings these days" Fletch F. Fletch

 

[janni78]

Yes, CLI works both ways.

You can use ICR to set outgoing CLI from IP Office as you would with an ISDN trunk towards a provider.

"Trying is the first step to failure..." - Homer

 

[sheldoom]

Sorry should have clarified, Will this solution provide both CLID name and number, as we had them setup with p-t-p PRI but did not get CLID name either way?

"It's all ball bearings these days" Fletch F. Fletch

 

[sizbut]

So you do have caller ID. Classic caller ID through PRI is number only. Name is not standard.

You could try adding ZU to the short code routing the outgoing calls from the IP Office but that's a guess.

Stuck in a never ending cycle of file copying.