Just had an OVD004 error pop up on my screen followed by the TN associated with the error. What would cause a single digital TN disable itself during the middle of the day. The TN is located on a fiber remote OPT11 cabinet.
First make sure it is a valid set. UNEQ and untermed sets have been known to give false codes. Otherwise, you could be looking at a variety of things, including wiring issues, port issues, etc.
Yes this is the first time it has happened. I enable the port and IDU the set and it comes back with the set info. It is a M3904. The remote cabinet, cards and sets are fairly new. They were installed about two years ago as an upgrade to one of the buildings I manage. I would suspect a wiring issue possibly but I thought I would mention this on this forum to get any feedback from those who has had the same issue.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.