Outlook 2007 and Outlook Popping

[Drew2400]

Has anyone successfully installed PM Pro and enabled Outlook screen popping with success for Outlook 2007? I have it installed on 2003 and it works fine. 2007 does not however. They can dial out through Outlook using TAPI without issue. Just can't pop outlook contacts with PM Pro.

Drew

 

[TomMills]

i did get it popping, but the contact kinda flashed for a bit, then settled down. looked awful so i turned it off.

 

[IPOfficeIreland]

yep, just set it up there, pops ok, but turn off PM POP as both are trying at the same time.

It flicks twice then opens but intusively in the front over what you are currently doing/typing.

Marks out of 10: 2 (can see it being disabled or unused after 3 days)

What I had been using before this was

http://www.identafone.com/cidpop.html

which is excellent - shows the caller id/name on your screen in a non intrusive motion. Cheaper than PM Pro also

Marks out of 10: 7.5 (would leave always enabled)

 

[TomMills]

yeah i had that flicking twice thing

 

[smoknonions]

I get the following error message after checking the Pop Outlook option in PMP: Outlook Cannot Be Configured!

 

[Drew2400]

With regards to the flickering thing. I seemed to think it went away if I turned off play sounds. Can't remember.
We have Vista and 2007. TAPI works (only in 32 bit apparently). However, POP OUTLOOK does not.
Drew

 

[IPOfficeIreland]

no, have all sounds off, all pops off but outlook. flickering still happens but does pop and does not require canonical format either, which is the only good thing.