Outgoing digit transmission

[MrTek8]

Hi all,

I have a BP250 connecting to ISDN PRI. I can receive calls but i cant make outgoing calls. Problem is, the local telco service provider says am sending single digits at a time to his switch and therefore they cannot terminate my calls. The provider says i must send all the dialled digits to his network as one block. Does anyone know how to change this on the BP250?

 

[Belyaev]

use command 1317 on all tranks.

 

[teenu2]

Hi all

i have a question about the same subject
what will be the cammand in mx-one to achive the same.

 

[MrTek8]

Belyaev, many thanks. It works like magic!

Teenu2, in RODDI change the first parameter in ADC to 1. Then define min and max number length with NANLS:EXL= ,MIN= ,MAX= ;