outgoing DID NEC 2000IPS 2

[imeldesign]

I needed to add some extensions to our school. I wanted the outgoing DID to display the school's main DID number instead of the church.
So I did the this in MOC:
cm 5005 > 01 where bin 1 was the bin I created last year for the main school number (however it only shows 251-660)

cm 1213> F8
2135 F8
assign bin 01

cm 1212 assign to NONE (but the main extension which used to work says 2427 which is the last four didgits of the DID

I have even created a new bin 04 with the correct 10 didgit outgoing number and set the CM 1213 and 1212 as they should be.
It still reads the main church number.

Any suggestions?

 

[grh959]

What is cm 3034 set to for your trunks?

Gary

http://www.gcti.com/contact.asp

 

[ctvi]

Grh959 is probably correct.

Note that when sending the caller id out on a trunk basis, you can put in the entire number in 5005. When sending the station caller id, you use the first 6 digits from the trunk and the last 4 digits from the station.

See below From

http://www.2000stuff.com

Sending Caller ID to Network. Trunk basis.
1. CM 3034>200~222>00 To each Voice trunk (200~222) assign a Local Office Code Table number (00).
There are 15 tables available 00~14.
2. CM 5005>00>XXXXXXXXXX Assign to the table number set in step 1 (00) a 10 digit number to be
projected to the network when a call is made on the ISDN PRI.
Sending Caller ID to the Network. Station Basis
Note: If station base is set it will override trunk basis.
1. CM 1212>Station number>XXXX To the station assign the last 4 digits of the caller ID to be projected
to the network.
2. CM 1213>Station number>01 To the station assign a Local Office Code Table number (01). There are
15 tables available 00~14. These are the same tables utilized by CM 3034 above.
3. CM 5005>01>XXXXXX Assign to the table number (01) set in step 2, a 6 digit number (area code +
office code) to be added in front of the four digit number in step 1.

http://www.ctvi.com

 

[imeldesign]

Thanks to you both. I did figure it out.