Probably a stupid question but here goes,
I have a m1 opt11c connected to a seperate telephony server.
I have accounts setup on the secondary say ext 3141, I log into the second server and place a call over a DPNSS tie into the M1, works ok using IDC entries, 3141 is actually 7191 on the M1.
I have setup pretranslation tables in LD18 and reverse dialling is also ok (M1 is not connected to the PSTN), however my question is this.
Can I manipulate the CLI passed over the DPNSS tie, i.e., If I dial from Ext 7191 from M1 and I want to present 3141 at the far end so that the secondary can do a quick lookup to see that it is me.
Any ideas
Rgds
Jason
I have a m1 opt11c connected to a seperate telephony server.
I have accounts setup on the secondary say ext 3141, I log into the second server and place a call over a DPNSS tie into the M1, works ok using IDC entries, 3141 is actually 7191 on the M1.
I have setup pretranslation tables in LD18 and reverse dialling is also ok (M1 is not connected to the PSTN), however my question is this.
Can I manipulate the CLI passed over the DPNSS tie, i.e., If I dial from Ext 7191 from M1 and I want to present 3141 at the far end so that the secondary can do a quick lookup to see that it is me.
Any ideas
Rgds
Jason