Customer has MICS, 6.1 SW, and PRI. 3 companies use the same phone system. Outbound caller id always shows only 1 company. Is there a way that they can control the sending of outbound caller id digits so that the far end sees the appropriate cid info? Much thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
outbound caller id with PRI 1
- Thread starter TallDW
- Start date
-
1
- #2
lugerlover
Programmer
yup as long as provider lets uyou ..its on a per set basis
OLI
OLI
RikRodgers
Vendor
Terminals&Sets,Line Access,OLI.
If you use on one set, program it on all of them. And as lugerlover said, check with the CO to make sure they support it. If you're using NI2 protocol, you shouldn't have any trouble.
If you use on one set, program it on all of them. And as lugerlover said, check with the CO to make sure they support it. If you're using NI2 protocol, you shouldn't have any trouble.
- Status
Similar threads
- Locked
- Question
- Question
