Out Going CLI its not showing the extension Number

[JAAGB]

Hi all,
From My extension if i call any one the CLI its showing the main pilot number..its not shwoing the extension number...where could be define


REQ: prt

TYPE: clid

CUST 0

SIZE 24
RNGE


INTL

ENTRY 0
HNTN
HLCL
DIDN YES
HLOC
LSC
CLASS_FMT DN

 

[lretrievers]

If you do not send out a valid CLID, the carriers in my area will convert the number to the main billing number riding the span.

In your situation, you need to enter the NPANXX on the CLID table, either in the HNTN (where it would be NPANXX) or in the HNTN enter the NPA and HLCL put the NXX. The way you enter it depends on your CO and whether they need to see 7 or ten digits outplsed for local calls.

 

[JAAGB]

The CO sending us the last 5 digits we are sending back the last 5 digits only

 

[lretrievers]

Inbound is different than outbound. Usually you must send a valid CLID, not just the extension number. 5 digits is what you are translating on for inbound calls. Try sending out a 7 or 10 digit number.