Orange Light on Serial0/0/0:0 connection to AT&T(internet) 1

[robspwing]

Hi all thanks in advance,

I have a Cisco 2811 router with an amber/orange light on the S0/0/0:0. The internet works so I am assuming it is just an alarm.
I did a Show Interfaces and the results are below
I am a little concerened about the 1650689 input errors, Total output drops: 10533, and the 176 interface resets. I am not sure if this is normal, any ideas or suggestions?



Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 10533
Queueing strategy: weighted fair
Output queue: 0/1000/64/10526 (size/max total/threshold/drops)
Conversations 0/207/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1152 kilobits/sec
5 minute input rate 550000 bits/sec, 90 packets/sec
5 minute output rate 151000 bits/sec, 73 packets/sec
184215902 packets input, 3805689934 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
1650689 input errors, 1650689 CRC, 703945 frame, 393673 overrun, 0 ignored,
1238125 abort
174199416 packets output, 1684914843 bytes, 0 underruns
0 output errors, 0 collisions, 176 interface resets
0 output buffer failures, 0 output buffers swapped out
10 carrier transitions
Timeslot(s) Used:1-24, SCC: 0, Transmitter delay is 0 flags

Rob

Doc, we better back up. We don't have enough road to get up to 88.

 

[burtsbees]

BAd---Have the telco do an aggressive test to the LEC...

/

tim@tim-laptop ~ $ sudo apt-get install windows
Reading package lists... Done
Building dependency tree
Reading state information... Done
E: Couldn't find package windows...Thank Goodness!