I got 6 8600 passports in the following config:
A=B---Full-mesh-SMLT---C=D---Full-mesh-SMLT---E=F
"=" sign is the IST link between passports. They are all inside the same Management VLAN.
All passports have the same ro and rw SNMP community strings, and they are all having the same firmware (3.5.1.0)
The problem is that when I use the Autotopology Manager to detect the routers, only A,B,E,F were detected and shown as "Layer-3 devices". I read back the log and it said C,D were detected successfully but I cannot display them.
Anyone experienced this problem before?
A=B---Full-mesh-SMLT---C=D---Full-mesh-SMLT---E=F
"=" sign is the IST link between passports. They are all inside the same Management VLAN.
All passports have the same ro and rw SNMP community strings, and they are all having the same firmware (3.5.1.0)
The problem is that when I use the Autotopology Manager to detect the routers, only A,B,E,F were detected and shown as "Layer-3 devices". I read back the log and it said C,D were detected successfully but I cannot display them.
Anyone experienced this problem before?