OptiPoint 410 headset programming question.

[Frav82]

Good Morning Everyone,

I moved a Plantronics CS540 headset and lifter unit from the bottom of an OptiPoint 410 phone and then attached both to another OptiPoint 410. I'm assuming there is a piece of programming that I'm missing on the new phone to allow it to pick up calls pressing the headset button. I displayed both phones using "DIS-SBCSU:xxxx;" and the only difference I see is the following, however, I'm not sure how to change it. Can anyone tell me how to change the Headset setting in the new phone from "N" to "NOIND"?

New OptiPoint 410 = "HEADSET =N"
Old OptiPoint 410 = "HEADSET =NOIND"

Thank you have a good Wednesday.

Rob

OpenScape 4000 V7 R2

 

[Frav82]

Got it, thanks.

CHA-SBCSU:3741,,,,,,,,,,,,,,,,,,,,,,,OPTI,,,,,,,,,,,,,,,,,,,,NOIND;

OpenScape 4000 V7 R2