Option11 expansion shelf

[NZTech]

hello everyone.
I would like to move my Op11 Expansion shelf (only), over to another building (about 1km away ).
The cabinets are currently connected via 10 metre plastic Fibre, Using -
NTBK54AC MFI and NTBK55AC EFI units.

I have multimode fibre cable available between buildings.

Is there a nortel product or some way to make the expansion shelf work over 1km of multimode fibre?
Has anyone done something like this?

Thanks
Steve

 

[one234]

Hi,

If you install a 3Km (1.8mi) fibre daughterboard and a 3Km reciever card you can connect a cabinet xKM (Guess ) Km away...

You should need the following hardware:

NTDK24 Fiber Expansion daughterboard (Multi Mode)
NTDK25 Fiber Receiver Card (Multi Mode)

NTDK79 Fiber Expansion daughterboard (Single Mode)
NTDK80 Fiber Receiver Card (Single Mode)

Marc D.

No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.

 

[dnc16]

I thought the 3 KM fibre cards only worked on single mode fibre, although I could be wrong. Can anyone confirm this?

 

[one234]

Well I got this from the NTP's so this should be right...

No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.

 

[NZTech]

Thanks guys - I'll check out the cards.
Steve

 

[vztech]

one234 is correct.