Option Mini - Problems with Terminal

[lislis]

Hello
I'm a little bit confused... I'm using Reflectoin terminal.
I could access and work on every system with no problems. Now I'm supporting Option Mini and there is some strange behaviour - I don't know if it's Meridian fault or my software terminal problem.
I can log into sytem and everything is just fine until - an error message comes on screen
>
OVL000
>ld
)~OY1
&quotH!C
If there is an error Message it's printed in wrong way - some strange chars.
It happens with most of error messages except for SCH and all confirmation like OVL000, DCH000

Any ideas?

 

[Sennback]

Wich port are you connected to?
Port 0 on the SSC card?
If you are using a port on a SDI/DCH card I could understand. They sometimes tend to have strange behavior from time to time.

cold be necessary to restart or change.

Otherwise, check speed, and the usual parity etc.

I have never seen any problems with the mini system.
Some old versions of the SSC cards should be changed but I dont think this should be the result of that problem.

 

[BMiles2000]

It is your parity setting!

 

[lislis]

Thanks for help
It was setting of data bits (was 7/1 I've changed it to 8 and it works fine now)
lis